300Amp Engineering Construction High Performance ARC Manual Welder

Check the internal circuit connection of the welder regularly to make sure that the circuit connection is correct and the connection head is firm (especially the insert connector or component). If rust or looseness is found, sand paper should be used to grind off the rust layer or oxidation film, reconnect it and tighten it.Check all cable insulated leathers regularly for any breakage, or else bind up or replace the cable.

To avoid electrostatic damage to semiconductor components and circuit boards, please wear anti-static devices, or by touching the metal parts of the case to remove static electricity beforehand touching the wiring conductor and circuit board inside the welder.

Avoid water or water vapor entering the welder. Dry it if damped inside. Then, measure the insulation of the welder with an ohmmeter (between the connection nodes and between the connection point and the housing). Be aware that continuous welding is performed only when no abnormalities are found.If the welder is idle for a long time, put it in the original packaging case and stored in a dry environment.